Mazda 1975 Rotary Pickup Workshop Manual page 109

\
7
iiall the back-up lamp switch
g and tighten the switch.
'lert the speedometer driven
: \lension housing and secure
'-'k plate.
C o n t r o l r o d
7-35 Friction piece
Fig. 7-35
Friction piece
l'-ice the gasket on the rear of the transmission
.,::d position the extension housing on the trans-
:, case with the gearshift control lever end laid
, :o the left as far as it will go. Tighten the
:": : t s nut s.
Fig. 7-36 Installing extension housing
fheck to ensure that the gearshift control lever
::es properly.
Irsert the select lock spindle and spring from
rside of the gearshift lever retainer. Position the
'
ball and spring in alignment with the select
. spindle and tighten the spring cap bolt.
50. Position the gasket and gearshift lever retainer to
the extension housing, and tighten the attaching bolts.
51. Check the bearing end play as follows:
Measure the depth of the main drive shaft bearing
bore in the clutch housing using a depth gauge. Then,
measure the bearing height shown in Fig. 7-38. The
difference between two measurements indicates the
required thickness of the adjusting shim. The stand-
ard clearance is 0 - 0.1 mm (0 N 0.0039 inl. If
necessary, select and use the properly sized shim.
The shims are available in the following thickness:
0.L mm (0.0039 in)
|
0.r? mm (0.0118 in)
52. Apply lubricant to the lip of the oil seal in the
clutch housing.
53. Place the gasket on the fornt side of the case
and install the clutch housing to the case. Tighten
the attaching uts.
54. Install the release bearing, release fork and release
fork boot to the clutch housing.
7- E . T R A N S MI S S I ON IN S T A L L A T I ON
Follow the removal procedures in the reverse order.
to the extension
gear assembly to
it with the bolt
l .
2.
3 .
Fig. 7-38 Measuring bearing height
Fig. 7-39 Measuring bearing bore depth
lock spindle
1 0