Mazda 1975 Rotary Pickup Workshop Manual page 130

7A
1.20 mm (0.047 in),
1.60 mm (0.063 in),
2.00 mm (0.079 in),
1.40 mm (0.055 in),
1.80 mm (0.071 in),
2.20 mm (0.087 in)
j
jrsmission case. Then install and tighten the con-
,.:ter housing onto the transmission case with six
.ts to 4.5 -
5.5 m-kg (33 -
40 ft-lb). Insert the
rut shaft.
\ote :
\bove two end plays should be checked after the
:. pump is properly installed and adjusted following
-
a n d 1 8 .
-
Push the front clutch drum back and forth and
:.:ert a thickness gauge in the clearance between the
:.rnt clutch drum and connecting strell in order to
-'.easure the end play between the rear face of the
:i pump cover and the front face of the front clutch
:nm. Select a thrust washer from rhe following
,.:ven washers to adjust the clearance to specified 0.5
- 0.8 mm (0.020 -
0.031 in).
1.50 mm (0.059 in),
1.90 mm (0.075 in),
2.30 mm (0.091in),
2.70 mm (0.106 in)
1.70 mm (0.067 in),
2.I0 mm (0.083 in),
2.50 mm (0.098 in),
Fig. 7A-49 Checking end play
18. In measuring the total end play, apply the dial
gauge on the tip of the input shaft and move the
connecting shell fore and aft, and read the needle
nbration. The standard clearance is 0.25 - 0.50 mm
(0.010 -
0.020 inl. Adjust end play by selecting a
proper race in the followings.
Fig. 7A-52 Tightening stem
20. Push in the manual shaft into the case
manual plate, washer and nut and tighten the
Then mount the parking lever and parking rod.
21. Install the range select lever to the manual
with the washer and nut then tiehten the nut.
Fig. 74-48 Assembling clutches
Fig.74-50 Checking end play
I r a n s m r s s t o n c a s e
T o t a l e n d p l a y
Fig. 7A-51 End plays
19. Tighten the stem of the servo piston to a torque
of 1 .2 -
1 . 5m - kg ( 9 - 1 1f t - l bl . T he n l oo se n i t b y
two turns and lock with the lock nut to a tightening
torque of 3.0 - 4.0 m-kg 122 -
2gft-lb).
Install and tighten the band servo cover to the retainer.
with
n u t .
shaft
7 A : 2 0