Se ction 5
O p e r a t i o n
This section provides information concerning the use of various options and applications required by
your system. It may be helpful to refer to Figures 3-1 and 3-2 that illustrate the major components in
the SG 2000 lid and RF chassis.
F o r w a r d P a t h R F C o n f i g u r a t i o n
You can configure the SG2-lid motherboard (LIDB) using three different forward path RF options.
Single Receiver Mode
If you are using a single optical receiver module (SG2-LR) it must be installed in position C. An
SG2-FJB/P jumper board must also be plugged into the LIDB. Figure 3-1 illustrates the location of
this jumper board.
The SG2-LIDB distributes an RF signal from the primary receiver (C) to the RF chassis as illustrated
in Figure 5-1:
F i g u r e 5- 1
Si ngl e r e ce iv e r
Optical
JXP
receiver C
Optical
JXP
receiver B
Optical
JXP
receiver A
SG2-FJB/P
JXP
Relay
S G 2 0 0 0 I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l
A
RF chassis