Introduction - Motorola PMP 400 Series Supplement To User’s Manual

Networks, bridges
Hide thumbs Also See for PMP 400 Series:
Table of Contents

Advertisement

PMP 400 and PTP 200 Series

1 Introduction

This guide provides product description, planning, configuration, and installation information
specific to the PMP 400 Series networks and PTP 200 Series bridges. It should be used along
with the Canopy System Release 8 User Guide, which covers general information, including all
network features, RF control features, and GUI (Graphical User Interface) features common
across PMP 100, 200 and 400 Series networks and PTP 100 and 200 Series bridges. The
Canopy System Release 8 User Guide is available from the "User Guides" section of the Canopy
Document Library, http://motorola.canopywireless.com/support/library/?region=1&cat=8.
This guide assumes that the reader has general RF (Radio Frequency) and Internet Protocol (IP)
knowledge and background.
This issue, Issue 2, is consistent with features provided by Canopy Release 8.4.3. Separate
Release Notes for Canopy Software Release 8.4.3 are available and include open issues and
other notes.
1.1
ABBREVIATIONS
The following abbreviations may be used in these notes:
1X
2X
3X
AP
BH
BHM
BHS
CMM
CNUT
DFS
EIRP
ETSI
FSK
MIB
OFDM
PtP
PtMP
QAM
QPSK
RF
SM
1.2
DOCUMENT CHANGE HISTORY
Issue 1
Issue 2
Issue 3, January 2009
1X operation, with typical max aggregate (up and down)
throughput of 7 Mbps (2 Mbps for 900 MHz)
2X operation, with typical max aggregate (up and down)
throughput of 14 Mbps (4 Mbps for 900 MHz)
3X operation, with typical max aggregate (up and down)
throughput of over 20 Mbps
Access Point Module
Backhaul Module, either timing master or timing slave
Backhaul Module – timing master
Backhaul Module – timing slave
Cluster Management Module
Canopy Network Updater Tool
Dynamic Frequency Selection for radar avoidance
Equivalent Isotropically Radiated Power
European Telecommunications Standards Institute
Frequency Shift Keying
Management Information Base for SNMP
Orthogonal Frequency Division Multiplexing
Point-to-Point (Backhauls)
Point-to-Multi-Point (AP to SMs)
Quadrature Amplitude Modulation
Quadrature Phase Shift Keying
Radio Frequency
Subscriber Module
First Issue
Significant changes for:
Canopy User Guide Supplement
Page 4 of 45

Advertisement

Table of Contents
loading

Table of Contents