Toyota 2002 Sequoia Owner's Manual page 198

Compass sensor
The compass sensor is on the roof of
the vehicle.
NOTICE
Do not put magnets or a metal object
on or near the roof of the vehicle.
Doing this may cause malfunction of
the compass sensor.
192
02_SEQUOIA_U (L/O 0108)
CALIBRATING THE COMPASS (deviation
calibration)
The direction display on the compass
deviates from the true direction deter-
mined by the earth's magnetic field. The
angle of deviation varies according to the
geographic position of the vehicle.
To adjust for this deviation;
1. Stop the vehicle in a level place and
switch the display to the outside tem-
perature. (To switch to this mode, see
"—Outside temperature and cruise in-
formation display" on page 189 in this
section.)
2. Push and hold both the "MODE" and
"E/M" buttons simultaneously for 5 sec-
onds until the "VAR" indication appears
on the compass display.
3. Push the "E/M" button several times
until the desired zone number appears
on the compass display.
If the button is not pushed for 10 sec-
onds, the display returns to the compass/
outside temperature mode and the number
that is last set is memorized.
To select the zone where the vehicle is
currently located, refer to the following
map.
2002 MY SEQUOIA_U (OM34418U)