Toyota 2002 Sequoia Owner's Manual page 145

Table of Contents

Advertisement

Advice for driving on slippery roads in
"L4" (low speed position) mode
If you shift the front drive control lever to
"L4" and the automatic transmission lever
to "D" or "2" when you drive in steep
off−road areas, the output of the brake
can be controlled effectively by the active
traction control system, which assists the
driver to control the driving power of 4
wheels.
Use the "L" position of the automatic
transmission lever for maximum power
and traction when your wheels get stuck
or when you drive down a steep incline.
To control the output of the brake effec-
tively, observe the following directions;
In the case of uphill driving with the
D
front drive control lever positioned in
"L4" and the transmission shift lever
positioned in "L", make sure the center
differential lock indicator comes on with
your vehicle placed at the level.
When the center differential lock indica-
D
tor flashes after operating the front
drive control lever, "4WD" switch or the
transmission shift lever, drive straight
ahead while accelerating or decelerat-
ing, or drive in reverse.
02_SEQUOIA_U (L/O 0108)
(b) A.D.D. (automatic
disconnecting differential)
The A.D.D. can be engaged or disen-
gaged by the shifting operations des-
cribed in "(c) Shifting procedure".
You should drive in four−wheel drive for
at least 16 km (10 miles) each month.
This will assure that the front drive com-
ponents are lubricated.
2002 MY SEQUOIA_U (OM34418U)
(c) Shifting procedure
SHIFTING BETWEEN "H" (2WD) MODE
AND "H" (4WD) MODE
To shift from "H" (2WD) mode to "H"
(4WD) mode, reduce your speed to less
than 100 km/h (62 mph) and push in the
"4WD" switch.
If the indicator light flashes when you
push in the "4WD" switch, drive straight
ahead while accelerating or decelerating.
If the indicator light flashes and the buzz-
er sounds when you push in the "4WD"
switch, reduce your speed or stop the
vehicle.
CAUTION
Never
push
the
"4WD"
switch
wheels are slipping. Stop the slipping
or spinning before shifting.
To shift from "H" (4WD) mode to "H"
(2WD) mode,
push the "4WD"
again to turn it off.
This can be done at any vehicle speed.
If the indicator light flashes when you
push in the "4WD" switch, drive straight
ahead while accelerating or decelerating,
or drive in reverse.
if
switch
139

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents