Toyota 2003 Matrix Owner's Manual page 17

"PANIC" SWITCH
Pushing the "PANIC" switch blows the
horn intermittently and flashes
headlights, turn signal lights and interi-
or lights.
The "PANIC" switch is used to deter ve-
hicle theft when you witness anyone at-
tempting to break into or damage your
vehicle.
The alarm will last for one minute. To stop
alarm midway, do the following:
Push the "PANIC" switch once again.
D
Unlock any of side doors, back door or
D
glass hatch with the key or wireless
remote control transmitter.
'03 MATRIX_U (L/O 0201)
Turn the ignition key from the "LOCK"
D
to "ON" position.
The "PANIC" mode does not work when
the ignition key is in the "ON" position.
WIRELESS REMOTE
TRANSMITTER
The wireless remote control transmitter is
an electronic component. Observe the fol-
lowing instructions in order not to cause
damage to the transmitter.
Do not leave the transmitter on places
D
where the temperature becomes high
such as on the dashboard.
Do not disassemble it.
D
Avoid knocking it hard against other
D
the
objects or dropping it.
Avoid putting it in water.
D
You can use up to 4 wireless remote con-
trol transmitters for the same vehicle.
Contact your Toyota dealer for detailed
information.
If the wireless remote control transmitter
does not actuate the doors or alarm, or
operate from a normal distance:
Check for closeness to a radio trans-
D
mitter such as a radio station or an
airport which can interfere with normal
operation of the transmitter.
2003 MY COROLLA MATRIX_U (OM12767U)
The battery may have been consumed.
D
Check the battery in the transmitter. To
replace the battery, see "REPLACING
TRANSMITTER BATTERY".
If you lose your transmitter, contact your
CONTROL
Toyota dealer as soon as possible to
avoid the possibility of theft, or an acci-
dent. (See "If you lose your wireless re-
mote control transmitter" on page 217 in
Section 4.)
MODEL/FCC ID: GQ43VT27R
CAN: 1470 104 105A
MADE IN U.S.A.
This complies with Part 15 of the FCC
rules. Operation is subject to the follow-
ing two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause unde-
sired operation.
13