Configuring Tcp/Ip - Motorola SB5100 Series User Manual

Introduction Before You Begin
SB5100 Series Cable Modem User Guide
Installation & Configuration

Configuring TCP/IP

The SURFboard cable modem contains all required software. You do not need to
configure the cable modem, but you must be sure that your computer is configured for
TCP/IP (a protocol for communication between computers). Perform one of:
•
"Configuring TCP/IP in Windows 95, Windows 98 SE, or Windows Me"
•
"Configuring TCP/IP in Windows 2000"
•
"Configuring TCP/IP in Windows XP"
•
Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the
•
"Verifying the IP Address in Windows 95, Windows 98 SE, or Windows Me"
page 37
•
"Verifying the IP Address in Windows 2000 or Windows XP" on page 38
•
Follow the instructions in your Macintosh or UNIX user manual
Your cable service provider may provide additional instructions to set up your computer.
Troubleshooting FAQ
on page 26
on page 30
Glossary License
on page 23
IP address:
on
22