Mazda 2013 Mazda3 Owner's Manual page 366

14. Prompt: "XXXXXX - - - (Ex.
"Stan's device") (Device tag). Is this
correct?"
15. Say: [Beep] "Yes"
16. Prompt: "Pairing complete"
After a device is registered, the system
automatically identifies the device. By
activating Bluetooth
or by activating Bluetooth
first after switching the ignition from OFF
to ACC, the system reads out a voice
guidance, "XXXXXX - - - (Ex. "Stan's
device") (Device tag) is connected".
NOTE
Device registration can also be done by
l
operating the audio unit.
Refer to Bluetooth® Audio Preparation on
page 6-110.
Depending on the device, the registration
l
status may be lost after a certain period of
time. If this occurs, repeat the entire
process from Step 1.
qMaking a Call Using a Telephone
Number
NOTE
Practice this while parked until you are
confident you can do it while driving in a non-
taxing road situation. If you are not completely
comfortable, make all calls from a safe
parking position, and move out only when fully
under control and you can devote your eyes
and mind to driving.
1. Press the pick-up button or talk button
with a short press.
2. Say: [Beep] "Dial"
3. Prompt: "Number, please"
4. Say: [Beep] "XXXXXXXXXXX
(Telephone number)"
®
Hands-Free again,
®
Hands-Free
Bluetooth® Hands-Free (Type A)
5. Prompt: "XXXXXXXXXXX.
(Telephone number) After the beep,
continue to add numbers, or say Go-
Back to re-enter the last entered
numbers, or press the Pick-Up button
to execute dialing."
6. (Dialing)
Press the pick-up button or say "Dial",
then go to Step 7.
(Adding/inputting telephone
number)
Say, "XXXX" (desired telephone
number), then go to Step 5.
(Telephone number correction)
Say, "Go Back". The prompt replies,
"Go Back. The last entered numbers
have been removed.". Then go back to
Step 3.
7. Prompt: "Dialing"
NOTE
The "Dial" command and a telephone number
can be combined.
Ex. In Step 2, say, "Dial 123-4567", then,
Steps 3 and 4 can be skipped.
Interior Comfort
6-125