IKEA BEJUBLAD Manual page 19

ENGLISH
Problem
The oven does not heat up.
The oven lamp does not op-
erate.
The Pyrolysis does not start.
The display shows C1.
The Pyrolysis does not start.
The display shows C2.
The Pyrolysis does not start.
The display shows C3.
The display shows F102.
The display shows an error
code.
Steam and condensation
collect on the food and in
the oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
We recommend that you write the data here:
Model (MOD.)
Possible cause
The fuse in the fuse box is
released.
The oven lamp is defective.
The shelf supports are not
removed.
The Pyrolysis or Defrost
function is set when the plug
of the core temperature sen-
sor is in the socket.
The door is not fully closed
or the door lock is defective.
The door is not fully closed
or the door lock is defective.
There is an electronic fault.
You left the dish in the oven
for too long.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
not remove the rating plate from the appli-
ance cavity.
Remedy
Do a check of the fuse. If the
fuse is released more than
one time, contact a qualified
electrician.
Replace the oven lamp.
Remove the shelf supports.
Remove the plug of the core
temperature sensor from the
socket.
Fully close the door.
1. Fully close the door.
2. Deactivate the appli-
ance with the house
fuse or the safety switch
in the fuse box and acti-
vate it again.
3. If the display shows
F102 again, contact the
service centre.
1. Deactivate the appli-
ance with the house
fuse or the safety switch
in the fuse box and acti-
vate it again.
2. If the display shows the
error code again, con-
tact the service centre.
Do not keep the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing ends.
.........................................
19