Operation; Using The Dryer - Bosch WTMC332RCN Operating, Care And Installation Instructions Manual

Operation

Using the dryer

1. Open the door.
2. Check lint filter.
The filter should be cleaned before
and after using the dryer. Cleaning
the filter reduces the drying time
and saves energy. (See page 19
for lint filter cleaning instructions).
i
Bleach may cause discoloration of
the dryer's colored surface.
Therefore, it is important to keep
bleach away from the colored
surface of your dryer. If any bleach
spills on the surface, use a moist
paper towel to thoroughly clean it
immediately.
3. Rotate program selector to the
desired program.
Select the program which
corresponds to the laundry in the
dryer from the program selection
table (see page 16).
The dryer light turns on inside the
drum.
i
The Start/Stop" indicator light
starts flashing.
18
4. If required, select an available
option ("Delicates low temp") by
pressing the corresponding button
(see figure above).
All available "Options" are
explained on page 16.
i The estimated remaining time will
be displayed.
5. Place laundry in the empty drum.
Put each piece of laundry into the
machine separately.
For best results the laundry to be
dried must be sorted according to
type of laundry and desired degree
of drying. For further information
see page 15.
i Observe drying symbols of the
laundry manufacturer. If drying
woolen clothing and shoes, see
the information on page 19.
Ensure that there is only laundry in the
drum. Check that all items are
completely in the drum.
6. Close the door.
The Start/Stop" indicator light
continues flashing.
i
If the door has not been closed
properly, the dryer will not start.
7. Press the Start/Stop" button. The
Start/Stop" indicator light
illuminates.
i The program starts with an
acoustic signal (if set).
If a standard program has been
selected, the indicator lights indicate
the progress of the program sequence.
i
At program end an acoustic signal
is emitted (if set) and the LED
Wrinkle block" illuminates.
i
When the drying process is
complete (program or selected
time program ended), the drum
rotates at specific intervals for
1 hour.
This prevents the laundry from
creasing. The laundry remains
loose and fluffy until it is removed.
The laundry should be removed
before this time has elapsed.
8. Open the door.
9. Take the laundry out of the dryer.
10. Rotate the program selector
to Off".
The dryer light goes out.
11. Clean the filter.
The filter should be cleaned after
each drying process. Cleaning the
filter reduces the drying time and
saves energy.
12. Close the door.