Program Selection Table; Options; Indicator Of Program Sequence - Bosch WTMC332RCN Operating, Care And Installation Instructions Manual

Program selection
For optimum drying results your dryer offers several program groups and
additional options.
Automatic programs include Regular/Cotton and Permanent press. Program selection is
based in part on the laundry fabric type. These programs are controlled via moisture sensors.
Program time is determined by the measured degree of moisture in the laundry and on the
degree of dryness selected (e.g. Damp dry, Regular Dry, Extra Dry).
Time programs run for a user specified length of time. The Air fluff/No heat timed cycle uses
ambient air (room temperature) without a heat supply and runs for 20 minutes.
Option Buttons
Delicates low temp.
Press the "Delicates low temp." button
for temperature sensitive textiles.
Observe the care information or
symbols on the textiles. The
temperature of the drying process is
reduced, the drying time is extended.
16
Signal
Your dryer outputs different signals for
certain events. You may enable or
disable the signal by pressing the
Signal button. The following audible
tones will be generated indicating the
status of the appliance.
Signal Type
Start Short tone
End Sequence of short
tones
Mal operation Sequence of long tones
Warning of Sequence of long tones
malfunction
i The signal
Warning of malfunction" is active
regardless of whether or not the
signal has been disabled.
LED Indicators of Program
Sequence
The dryer uses an electronic scanning
system for all programs except the time
programs . A moisture sensor
continuously checks the moisture in the
laundry. Drying ends automatically as
soon as the selected degree of dryness
has been reached.
The drum continues to rotate at
specific intervals for one hour to
prevent creasing.
The current degree of drying and the
level reached during the program
sequence is indicated via indicator
lights (Drying, Damp dry, Regular dry,
Wrinkle block).
i
If the indicator light Wrinkle block"
illuminates when the program
selector is in Off-Position - turn off
the circuit breaker and call for
customer service!