Error Codes - Canon EOS Rebel T6 Instruction Manual

Error Codes

Error number
Cause and countermeasures
Number
Communications between the camera and lens is faulty. Clean the
lens contacts.
01
 Clean the electrical contacts on the camera and lens or use a
Canon lens (p.25, 26).
Card cannot be accessed. Reinsert/change card or format card
with camera.
02
 Remove and insert the card again, replace the card, or format the
card (p.36, 52).
Cannot save images because card is full. Replace card.
04
 Replace the card, erase unnecessary images, or format the card
(p.36, 52, 230).
The built-in flash could not be raised. Turn the camera off and on
again.
05
 Operate the power switch (p.39).
10, 20 An error prevented shooting. Turn the camera off and on again or
30, 40 re-install the battery.
50, 60
Operate the power switch, remove and install the battery again, or

70, 80
use a Canon lens (p.36, 39).
99
* If the error still persists, write down the error number and contact your
nearest Canon Service Center.
298
If there is a problem with the camera, an
error message will appear. Follow the on-
screen instructions.
Error Message and Solution