Error Codes - Canon EOS 200D Instruction Manual

Error Codes

Error number
Cause and countermeasures
Number
Communications between the camera and lens is faulty. Clean the
lens contacts.
01
Clean the electrical contacts on the camera and lens, use a Canon
lens, or remove and install the battery again (p.27, 48, 38).
Card cannot be accessed. Reinsert/change card or format card
with the camera.
02
Remove and insert the card again, replace the card, or format the
card (p.38, 68).
Cannot save images because card is full. Replace card.
04
Replace the card, erase unnecessary images, or format the card
(p.38, 339, 68).
The built-in flash could not be raised. Turn the camera off and on
again.
05
Operate the power switch (p.42).
Sensor cleaning could not be performed. Turn the camera off and
on again.
06
Operate the power switch (p.42).
10, 20 An error prevented shooting. Turn the camera off and on again or
30, 40 re-install the battery.
50, 60
Operate the power switch, remove and install the battery again, or
70, 80
use a Canon lens (p.42, 38, 48).
99
* If the error message still appears after following the above instructions,
write down the error code number and contact your nearest Canon Service
Center.
If there is a problem with the camera, an
error message will appear. Follow the on-
screen instructions.
Error Message and Solution
427