Assembly And Set-Up - Razor RX200 Owner's Manual

ASSEMBLY AND SET-UP

Attaching the Handlebars
Tool Required: 5 mm Allen wrench
1
Loosen the collar clamp. With
a twisting motion, push and twist
to slide the handlebar stem onto
the fork.
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your
purchase. Always inflate tires to the correct PSI before first time use.
Rear Tire
1
Use the valve extender
located in the end of the right
handlebar grip.
Front Tire
1
Using a bicycle style tire pump
equipped for a Schrader-type valve,
inflate the front tire to the PSI
indicated on the sidewall of the tire.
RX200_MAN_US_141215.indd 4
2
With the front wheel pointed
straight ahead and the handlebars
square to the front wheel, tighten
three (3) bolts on the clamp as
shown with a 5 mm Allen wrench.
Tighten securely.
2
Thread the valve extender
completely onto the valve stem and
attach the pump. Inflate to the PSI
indicated on the tire sidewall.
3
Remove valve extender
immediately after inflating.
4
Note:
Make sure any cables/wires
are out of the way before inserting
the stem into the fork.
WARNING: Failure to
properly tighten the collar clamp
may allow the handlebars to
dislodge while riding and may cause
you to lose control and fall. When
correctly tightened, the handlebars
will not rotate out of alignment
with the front wheel under normal
circumstances.
Note: The cable and wire assembly
from the handlebar must not
wrap around the steering tube or
handlebar. Sharp bends or twisting
of the brake cable can cause the
brakes to malfunction.
WARNING: Failure to
remove the valve extender after
inflating will cause the inner tube
and/or adapter to be severed by the
disc brake.
Note: If you lose the valve extender,
contact customer service or one can
be purchased at almost any auto
parts store.
WARNING: Inflate the
tires to the recommended pressure
(60 PSI) before riding. Do not exceed
the tires' PSI rating. Over inflation
will cause a rupture and under
inflation may cause additional wear
on the tire.
WARNING:
Do not over inflate, as this could
damage tire or wheel.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate your
electric scooter tires, first make sure
the pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
12/15/14 5:42 PM