Before You Begin - Razor RX200 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the
box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 5 for charging information).
Charger
(Note: Charger design may vary
from one shown)
Valve Extender
(Inside Grip)
Twist Grip Throttle
Collar Clamp
Front Fork
Motor
Required Tools
5 mm Allen wrench
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
RX200_MAN_US_141215.indd 3
Brake Lever
Handlebar Stem
1.
On/Off Switch
Charger Port
Reset Button
Battery
Control Module
Valve Extender
(Located in right
handlebar grip)
3.
2.
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The scooter
has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of its
compatibility with the frame, fork and
all other parts. Certain aftermarket
products may not be compatible and
will void the warranty.
Product ID Locations:
See locations to the left
1. Handlebar Stem
2. Underneath battery tray
3. Charger
4. UPC side of box (not shown)
Plastic Bag Contents:
• Charger
• Tool
• Owner's Manual
12/15/14 5:42 PM