Emerson Portland CF965BS00 Owner's Manual page 7

3. Ceiling Fan Assembly
3.8
Carefully turn the partially assembled ceiling fan over and
NOTE: Be extra careful not to bend the ceiling fan
place it on the styrofoam for final preparation (Figure 5).
blades while turning the fan over onto the styrofoam.
NOTE: If using a longer accessory downrod, discard
the supplied 4.5" downrod and install the longer
downrod (sold separately) using the following
instructions.
3.9
Remove the hanger ball by loosening the setscrew in the
hanger ball until the ball falls freely down the downrod
(Figure 6).
Remove the pin from the downrod, then remove the
hanger ball.
Retain the pin and hanger ball for reinstallation in Step
NOTE: Do not loosen the screw holding the green
3.15.
ground wire.
3.10
Separate, untwist and unkink the two 80" motor leads.
Route the 80" black and white motor leads through the
downrod (Figure 7).
(Continued)
STYROFOAM
Figure 5
PIN
GREEN
GROUND
WIRE
Figure 6
TWO 80" MOTOR
LEADS (UNTWISTED)
Figure 7
Please contact 1-800-654-3545 for further assistance
7
CEILING FAN
(partially assembled)
HANGER BALL
SETSCREW
(LOOSENED)
4.5" DOWNROD
4.5" DOWNROD
emersonfans.com
ETL Model No.: CF965