Toyota 2008 Rav4 Owner's Manual page 28

Reorient or relocate the receiving an-
D
tenna.
Increase the separation between the
D
equipment and receiver.
Connect the equipment into an outlet
D
on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced
D
radio/TV technician for help.
FCC WARNING:
Changes or modifications not
pressly approved by the party respon-
sible for compliance could void the
user's authority to operate the equip-
ment.
For vehicles sold in Canada
NOTE
Operation is subject to the following two
conditions:
(1) this device may not cause interfer-
ence, and (2) this device must accept
any interference, including interference
that may cause undesired operation of
the device.
18
'08 Rav4_U (L/O 0802)
—Locking and unlocking
doors
ex-
Locking operation
Unlocking operation
To lock and unlock all the doors, push
the switches of the key slowly and se-
curely. At this time, the indicator light
on the key grip flashes once.
To lock: Push the lock switch. All the side
doors and back door are locked simulta-
neously. At this time one beep will be
heard, and the turn signal lights flash
once.
Check to see that all the side doors and
back door are securely locked.
The beep and flashing turn signal lights
can be disabled. For details, contact your
Toyota dealer.
If any of the side doors or the back door
is not securely closed, locking cannot be
performed by the lock switch and a beep
will sound continuously for 10 seconds.
However, if the key is in the engine
switch, a beep will not sound.
To stop the beep, close all the side doors
and back door securely or push the un-
lock switch.
The beep can be disabled. For details,
contact your Toyota dealer.
2008 RAV4 from Feb. '08 Prod. (OM42726U)