Engine (Ignition) Switch - Toyota 2008 Rav4 Owner's Manual

Engine (ignition) switch

"START"—Starter motor on. The key
will return to the "ON" position when
released.
For starting tips, see page 341 in Section
3.
"ON"—Engine on and all accessories
on.
This is the normal driving position.
"ACC"—Accessories such as the radio
operate, but the engine is off.
If you leave the engine switch in the
"ACC" or "LOCK" position and open the
driver's door, a buzzer will remind you to
remove the key.
142
'08 Rav4_U (L/O 0802)
"LOCK"—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
You must push in the key to turn the
engine switch from the "ACC" to "LOCK"
position. The selector lever must be in the
"P" position before pushing the key.
Vehicles with engine immobilizer
tem—Once you remove the key, the en-
gine immobilizer system is automatically
set. (See "Engine immobilizer system" on
page 15 in Section 1−2.)
When starting the engine, the engine
switch may seem stuck at the "LOCK"
position. To free it, first be sure the key
is pushed all the way in, and then rotate
the steering wheel slightly while turning
the key gently.
Approximately five hours after the engine
is turned off, you may hear sound coming
from under the floor around the driver's
seat for several minutes. This is normal
operation and does not indicate a malfunc-
tion. (See "Leak detection pump" on page
ix.)
It is not a malfunction if the needle on all
meters and gauges move slightly when the
engine switch is turned to the "ON" or
"START" position.
NOTICE
Do not leave the engine switch in the
"ON" position if the engine is not
running. The battery will discharge
and the ignition could be damaged.
sys-
2008 RAV4 from Feb. '08 Prod. (OM42726U)