Printer Problems (Connected Through Optional Docking Station); Printer Problems (Connected To Optional Docking Station) - Motorola L3391 Owner's Manual

l Make sure that the Standby or Suspend time-out is enabled.
The computer does not enter Standby or Suspend mode immediately.
l If the computer is performing an operation, it normally waits for the
operation to finish.
The computer does not resume from Standby or Suspend mode.
The computer automatically enters Standby or Suspend mode when the
battery pack is empty. Does any one of the following:
Connect the AC or car adapter to the computer.
Replace the empty battery pack with a fully charged one.
The computer does not enter Standby or Suspend mode with the
Fn + F10 hot keys.
l You might be using a PC Card that prevents the computer from
entering Suspend mode. To enter the mode, stop the communication
program and then remove the card or stop the card.
Printer Problems (connected through optional docking
station)
The printer does not work.
l Make sure that the printer is turned on (if with independent power
source) and is online (ready to use).
l Make sure that the printer's signal cable is properly connected.
l Make sure that the printer driver is correctly installed.
l Make sure that you have assigned the printer port correctly in your
operating system or application program.
l Make sure that the printer port is enabled in the SCU program.
The printer prints garbled information.
l Make sure that the printer driver is correctly installed.
l Make sure that the printer cable is properly connected.
8-12
Troubleshooting