Fan Speed And Airflow Direction Adjustment; Econo Cool Operation; Timer Operation; Airflow Direction - Mitsubishi Electric MSY-GJ10VA Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
F
AN SPEED AND
AIRFLOW DIRECTION ADJUSTMENT
Press to select fan speed. Each press changes
fan speed in the following order:
(AUTO) (Low)
• Two short beeps are heard from the indoor unit when set to AUTO.
Press to select airfl ow direction. Each press
changes airfl ow direction in the following order:
(AUTO) (1)
• Two short beeps are heard from the indoor unit when set to AUTO.
• Press for 2 seconds or more to set to horizontal position.
• Press once to cancel horizontal position.
• When the airflow direction is set to horizontal position, or when hori-
zontal position is cancelled, operation stops for about 3 minutes.

Airflow direction

(AUTO) .........The vane is set to the most effi cient airfl ow direction.
:horizontal position.
(Manual) .......For efficient air conditioning, select the upper position for
COOL/DRY, and the lower position for FAN. If the position (2),
(3), or (4) is selected during COOL/DRY, the vane automati-
cally moves to the horizontal position after 0.5 to 1 hour to
prevent any condensation from dripping.
(Swing) .........The vane moves up and down intermittently.
■ To change the horizontal airfl ow direction.
Move the vertical vane manually before starting operation.
En-5
(Med.) (High) (Super High)
(2) (3) (4) (SWING)
E
CONO COOL OPERATION
Press during COOL mode

ECONO COOL operation.

The unit performs swing operation vertically in various cycle according
to the temperature of the airflow. Set temperature is set 2°C higher au-
tomatically.
Press again to cancel ECONO COOL operation.
• Pressing also cancels ECONO COOL operation.
What is "ECONO COOL"?
Swing air fl ow (change of air fl ow) makes you feel cooler than constant air fl ow.
So, even though the set temperature is automatically set 2°C higher, it is pos-
sible to perform cooling operation with keeping comfort. As a result, energy can
be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or during operation to set the timer.
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
* or blinks.
* Make sure that the current time is set correctly.
2
Press (Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
3
Press or again to cancel timer.
Note:
• ON and OFF timers can be used in combination.
of timer operations.
• If power failure occurs while ON/OFF timer is set, see
function".
page 4 to start
Page 3
(Decrease) to set the
mark indicates the order
page 4 "Auto restart