Toyota 2005 MR2 Spyder Owner's Manual page 103

04 09.01
The selector lever is shifted from the
D
"N" position to the "S" or "R" position
soon after starting the engine.
In this case, shift the selector lever to the
"N" position once, and after a few sec-
onds, shift the selector lever again to the
"S" or "R" position.
When the selector lever is shifted to
D
the "S" position while starting the en-
gine, the selector lever position and
the gear position do not match.
In this case, shift the selector lever to the
"N" position once and confirm that the
engine has started. Then, shift the selec-
tor lever to the "S" or "R" position.
At the same time when turning the igni-
D
tion switch to the "ON" position and
shifting the selector lever from the "N"
position to the "S" or "R" position.
In this case, shift the selector lever to the
"N" position once, then shift the selector
lever again to the "S" or "R" position.
At the same time when turning the igni-
D
tion switch to the "OFF" position and
shifting the selector lever from the "N"
to the "S" or "R" position.
In this case, turn the ignition "ON" before
operate the shift lever. Shift the selector
lever to the "N" position once, then shift
the selector lever again to the "S" or "R"
position.
"N" indicator flashing and warning
buzzer (long pulse sound) beeping.
The system is re−trying shift operation
D
from the "N" to "S" or "R" position due
to shift failure.
Stopping for more than 90 seconds
D
without depressing the brake pedal,
while the engine is running with the
selector lever in the "S" position.
10 seconds after the driver's door is
D
opened with the selector lever in the
"S" position while the engine is run-
ning.
Turn the ignition switch to the "OFF"
D
position and shift the selector lever
from the "N" to "S" position at the
same time.
If this condition lasts for a long time, shift
the selector lever to the "N" position once
and shift the selector lever again to the
"S" or "R" position.
SD16022
"1st" indicator blinking
At the same time when turning the igni-
D
tion switch to the "ON" position and
shifting the selector lever from the "S"
position to the "N" or "R" position.
At the same time when turning the igni-
D
tion switch to the "OFF" position and
shifting the selector lever from the "S"
to "N" position.
In this case, shift the selector lever to the
"S" position once, then shift the selector
lever again to the "N" position.
2005 MR2 from Aug. '04Prod. (OM17527U)
95