Flush Mount To Existing 5S Box - Secura Key ENTRACOMP 26SA User & Installation Manual

FLUSH MOUNT TO EXISTING 5S BOX (See Figure 8)
1. Use wall cutout template provided. Align template over 5S
box. (When running wires to the 5S box, don't use center
top hole as it will interfere with housing lock.) Transfer
appropriate cutout corner locations of clearance hole for the
housing lock to the wall with pointed instrument.
2. Draw lines from point to point, outlining cutout.
3. Cut out opening, being careful not to make opening larger
than indicated on the template.
4. Mount mounting plate to 5S box using the four 8-32 flat head
screws provided. For an outdoor installation, silicone sealant
is recommended between the mounting plate and the wall.
5. Be sure all appropriate wiring has been connected to the
terminal board, and then plug the terminal board cable into
the socket on the circuit board (see wiring instructions).
6. Place reader and faceplate assembly against the mounting
plate. Faceplate will hook onto mounting plate by pushing
plate in and then sliding it down.
7. Secure faceplate to mounting plate using the two 4-40 screws
provided.
8. Place faceplate door into door opening and rotate key 90°
clockwise.
Secura Key • 20