Installation Instructions; Surface Housing To Single Gang Electrical Box; Surface Housing Without Electrical Box - Secura Key ENTRACOMP 26SA User & Installation Manual

INSTALLATION INSTRUCTIONS

SURFACE HOUSING TO SINGLE GANG ELECTRICAL BOX

(See Figure 4)
1. For exterior walls, apply 1/4 inch bead of silicone sealant
around rear perimeter surface of mounting bracket gasket.
Be sure there is sufficient sealant to make a good seal
between gasket and wall.
2. Use two 6-32 x 1 pan head screws provided to secure
mounting plate to box.
3. Connect power and control lines to wire leads provided as
per the wiring instructions.
4. Plug connector into reader board.
5. Place ENTRACOMP
top edge first, centering housing on retaining tabs. Secure
housing to plate at bottom using one 6-32 x 3/8 security
screw provided or equivalent.
6. Lock cam lock.

SURFACE HOUSING WITHOUT ELECTRICAL BOX

(See Figure 5)
1. For exterior walls, apply 1/4 inch bead of silicone sealant
around rear perimeter surface of mounting bracket gasket.
Be sure there is sufficient sealant to make a good seal
between gasket and wall.
®
26SA housing against mounting plate,
Secura Key • 15