Vanguard BDV37NC Owner's Operation And Installation Manual page 21

FIREPLACE
INSTALLATION
Continued
REMOVING/REPLACING
GLASS DOOR
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
CAUTION: Do not operate this
fireplace with a broken glass door
panel. Do not operate this fire-
place without the glass door panel
securely in place. For replace-
ment part information see Re-
placement Parts , page 30.
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 40).
2. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 41).
4. To replace glass door, follow the above
instructions in reverse.
Top Louver
Panel
Figure 40 - Removing Top Louver Panel
106515
Screw
Glass Door
Assembly
Figure 41 - Removing/Replacing Glass Door
INSTALLING OPTIONAL
WALL MOUNT SWITCH
GWMS2
NOTICE: The GWMS2 includes
25' of wire for installation. Your
fireplace includes 15' of wire for
accessory installation. Choose the
length that best fits your needs
when installing this accessory.
1. Connect one terminal of the provided
wire for the wall switch to the TPTH ter-
minal on the valve. Connect remaining
wire terminal to the TH terminal on the
valve. Make sure that the wire terminals
are in the positions on the unit as pic-
tured in Figure 42. If wires are not con-
nected as shown the switch will not work.
2. Route the wire through openings pro-
vided on the sides of the burner sys-
tem to a convenient location to mount
your switch.
21
OWNER'S MANUAL
Lower Bracket for
Glass Door Assembly
3. Connect one bare wire end to each of
the terminals of the GWMS2 wall
switch.
4. Install the wall switch and cover in the
wall.
Figure 42 - Control Valve Terminals
To Control
Switch or
Optional
Accessory
Continued