OpenTherm Bridge (R8810)
evohome
Controller
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
for 3
'Settings'
seconds
2. Press the green tick
3. Press SYSTEM
DEVICES
4. Press BOILER
CONTROL
5. Press OPENTHERM
BRIDGE
evohome Installation Guide
Power up and bind an OpenTherm Bridge
(R8810) to control an OpenTherm boiler
Make sure the OpenTherm Bridge (R8810) is wired
to the boiler and powered up.
To bind the OpenTherm Bridge
Press and hold the button for 15 seconds (until the red
1
LED blinks rapidly) to clear any previous binding data
Press and hold the button again for 5 seconds
2
(until the red LED blinks slowly)
On the evohome Controller press
3
the green bind button
You should receive a SUCCESS message on the
4
evohome Controller (if not go back and re-bind)
1
2
PRESS
AND HOLD
15 SEC
19
PRESS
AND HOLD
5 SEC