Daikin R-410A Split series Installation Manual page 9

Note:
1) Wrap the refrigerant pipes and drain hose together with insulation tape as
right figure, in case of setting the drain hose through the back of the indoor
unit.
2) If it difficult to fix the claws of the bottom frame on the catches of the
mounting plate.
Secure indoor unit to the mounting plate with scres (M4 × 12L).
3-3. Wall Embedded Piping
Follow the instructions given under
Left-Side, Left-Back, or Left Bottom Piping
1) Insert the drain hose to this depth so it wont be pulled out of the drain
pipe.
4.
Wiring.
With a Multi indoor unit
1) Strip wire ends (15 mm).
2) Match wire colours with terminal numbers on indoor and outdoor unit's terminal blocks and firmly screw wires to the corre-
sponding terminals.
3) Connect the earth wires to the corresponding terminals.
4) Pull wires to make sure that they are securely latched up, then retain wires with wire retainer.
5) Shape the wires so that the service lid fits securely, then close service lid.
I I I I Warning
Do not use tapped wires, stand wires, extensioncords, or starbust connections, as they may cause overtheating, electrical
shock,or fire.
IEnglish
, install as described in the installation manual supplied with the Multi outdoor unit.
Shape wires so that the
service lid will fit securely.
Firmly fix the wires with
the terminal screws.
When wire length exceeds
10 m, use 2.0-mm wires.
1
Indoor
2
3
unit
Firmly fix the wires with
the terminal screws.
Terminal block
1 2 3
Electrical component box
Wire retainer
Firmly secure wire retainer so that
wires sustain no external stress.
Use the specified wire type.
Outdoor unit
1 2 3 L N
Safety
Earth leakage
breaker
circuit breaker
15A
H05VV
Earth
Drain hose
Bottom frame
H M4 × 12L (2 point)
Insert drain hose
to this depth so
it won't be pulled
out of drain pipe.
50 mm Drain hose
or more
Vinyl chloride
drain pipe
Outer wall (VP-30)
Power
supply
50Hz 220V - 240V
60Hz 220V - 230V
A
Mounting
plate
Refrigerant
pipes
Inner wall
8