Cleaning Instructions; Front Panel; Indoor Unit; Nanoe-G Generator - Panasonic CS-A9PKD Operating Instructions Manual

Cleaning instructions

To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. Please consult authorised dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fi n, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap ( pH 7) or neutral household
detergent.
• Do not use water hotter than 40 °C.

Indoor unit

Wipe the unit gently with a soft,
dry cloth.
Human activity sensor
Do not hit or violently press or poke it with a sharp
object. This can lead to damage and malfunction.

Front panel

Wash gently and dry.
Remove the front panel
Pull out
2
1 Raise
Close it securely
Press both ends of
3
the front panel
2
Close down
For CS-A18PKD, CS-A24PKD, CS-A28PKD:
4
Press at center of the front panel.
10
F568955_YT0912-0.indb 10 F568955_YT0912-0.indb 10
Indoor unit
Front panel
Human activity
sensor

nanoe-G Generator

Every 6 months
• Clean with dry cotton bud.
• Do not touch during operation.
Air fi lters
Every 2 weeks
• Wash/rinse the fi lters gently
with water to avoid damage to
the fi lter surface.
• Dry the fi lters thoroughly under shade, away
from fi re or direct sunlight.
• Replace any damaged fi lters.
Remove air fi lter
1 Insert at
both sides
For seasonal inspection after extended
non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to
have the following temperature difference
between air inlet and air outlet vents:
For extended non-use
• Activate HEAT mode for 2~3 hours to remove
moisture left in the internal parts thoroughly to
prevent mould growth.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
Aluminium fi n
Air fi lters
Attach air fi lter
Insert into the unit
COOL: ≥ 8 °C HEAT: ≥ 14 °C
nanoe-G
Generator
12/17/2012 4:17:05 PM 12/17/2012 4:17:05 PM