Replacing Light Bulbs - Toyota 2005 Celica Owner's Manual

NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle's paint.
250
'05MY CELICA U (L/O 0409)

Replacing light bulbs—

The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not
D
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
D
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
Vehicles with discharge headlights—
Do not touch the high voltage sock-
D
et when the headlight turns on.
20000 V is momentarily generated
and may cause severe injury by
electric shock.
Do not disassemble, repair or take
D
apart the headlight bulbs, connec-
tor, power supply circuits and ro-
tated components. Or you may be
injured by electric shocks. Call your
dealer when the headlights fail to
work or have to be replaced or dis-
posed of.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
if
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
NOTICE
Only use a bulb of the listed type.
2005 CELICA from Sep. '04 Prod. (OM20888U)
like the
contact your