Arctic Cat plowler HDX 2013 Operator's Manual page 34

NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will "power-up,"
reset, and shut down repeatedly until
clock memory power is restored.
Always check the 15-amp accessory
fuse if this gauge condition is noted.
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the nor-
mal operating range, the temperature
icon will begin flashing and the LCD
will go blank for 30 seconds; then the
LCD will return to normal. However,
the temperature icon will continue to
flash.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.
NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.
NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a
garden hose, wash the radiator and
the engine to remove any debris
restricting air flow.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer, distance, and time.
32
NOTE: The Mode Button must be
pressed
speedometer/tachometer modes. It
must be pressed and held to shift
MPH/KPH modes.
4. Set Button - The Set Button is used to
select the gauge display of clock,
hour meter, trip 1, trip 2, and odome-
ter. It is also used to activate the clock
set function and adjust the minute dis-
play on the clock.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
6. Odometer/Trip Meter - Odometer reg-
isters the total distance the vehicle has
traveled. The trip meter is resetable
and can be used to measure trip or trip
legs. The odometer cannot be reset.
NOTE: To shift between the odom-
eter (ODO) or trip meter (TRIP),
press the Set Button (4) to select the
distance mode; then press the Mode
Button (3) to select the desired dis-
Decreasing
play. Hold the Set Button down to
reset the trip meter.
7. Gear Position Indicator - Indicates
which gear position is selected - R
(reverse)/N (neutral)/L (low range)/H
(high range)/P (park).
NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
8. High Beam Indicator - The High
Beam icon will appear only when the
headlights are on high beam.
9. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator - Displays 4WD
when selected by the drive select switch
or when the 4WD lock is engaged. The
display is blank when in 2WD.
and released to shift