Mercedes-Benz S-Class Coupe Operator's Manual page 373

Press 9 or : to select
X
sure .
Press the a button.
X
The current tire pressure of each tire is
shown in the multifunction display.
If the vehicle was parked for longer than
20 minutes, the Tire pressure will be
displayed after driving a few
minutes message appears.
After a teach-in process, the tire pressure
monitor automatically detects new wheels or
new sensors. As long as a clear allocation of
the tire pressure value to the individual
wheels is not possible, the
Monitor Active message is shown instead
of the tire pressure display. The tire pressures
are already being monitored.
Tire pressure monitor warning mes-
sages
If the tire pressure monitor detects a pressure
loss in one or more tires, a warning message
is shown in the multifunction display and the
yellow tire pressure monitor warning lamp
comes on.
If the Please Correct Tire Pressure
R
message appears in the multifunction dis-
play, the tire pressure in at least one tire is
too low and must be corrected at the next
opportunity.
If the Check Tires
R
multifunction display, the tire pressure in
one or more tires has dropped significantly
and the tires must be checked.
If the Warning Tire Malfunction
R
sage appears in the multifunction display,
the tire pressure in one or more tires has
dropped suddenly and the tires must be
checked.
Observe the instructions and safety notes in
the display messages in the "Tires" section
( page 279).
Y
If the wheel positions on the vehicle are rota-
ted, the tire pressures may be displayed for
the wrong positions for a short time. This is
Tire Pres‐
Tire Pressure
message appears in the
mes-
rectified after a few minutes of driving, and
the tire pressures are displayed for the cor-
rect positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here. The tire pressure monitor
then monitors the new tire pressure values.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar ( page 365).
Y
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
( page 365).
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock.
Use ò on the steering wheel to call up
X
the list of menus.
Press 9 or : on the steering wheel
X
to select the Service
Press the a button.
X
Press 9 or : to select
X
sure .
Press the a button.
X
The current tire pressure for each wheel or
the Tire pressure will be displayed
after driving a few minutes
Tire pressure
menu.
Tire Pres‐
message
Z
371