Table of Contents
Advertisement
2
INSTALLATION OVERVIEW
2.1
Introduction
This section provides hardware equipment information for installing the GTX 32 Transponder, related
hardware and optional accessories. Installation of the GTX 32 should follow the data detailed in this
manual. Cabling is fabricated by the installing agency to fit each particular aircraft. The guidance of
FAA advisory circulars AC 43.13-1B and AC 43.13-2A, where applicable, may be found useful for
making retro-fit installations that comply with FAA regulations.
Refer to the G1000 System Installation Manual, Garmin part number 190-00303-00 for further details on
the mechanical aspects. For installation in an aircraft using the remote mounted stand-alone rack refer to
Appendix B for rack drawings and dimensions.
2.2
Installation Materials
The GTX 32 is available as a single unit under the following part numbers:
GTX 32 (011-00768-00)
2.2.1 Equipment Available
Each of the following accessories is provided separately for the GTX 32 unit and is required for
installation.
G1000 Install Rack, GTX 32
G1000 Nutplate Kit
GTX 32 Remote Stand-Alone Install Rack
(Alternate Configuration)
Connector Kit, GTX 32
Backplate Assembly, GTX 32
Garmin Transponder Antenna kit*
*Note: A transponder antenna approved to TSO C66( ) or C74( ) that has been installed to meet
the requirements of this manual may be used with the GTX 32.
GTX 32 Installation Manual
190-00303-60
Item
Item
Catalog Part Number
010-00265-00
Garmin Catalog Part Number
115-00439-00
011-00915-01 (preferred) or
011-01148-01
Or
115-00628-00
011-01013-00 (SPIDER) or
011-01013-01 (Shield Block)
011-00677-01
010-10160-00
Page 2-1
Revision F
Hide quick links:
Advertisement
Table of Contents
