Connecting The Radio Antenna - Magellan MG-6060 Reference And Installation Manual

rubber stops prevent the console from sliding when Magellan is
being used. To do so:
1. Place the console back plate flush against the wall plate.
2. Slide the Magellan's open slots labeled D (see Figure 14 on
page 11) onto the wall plate's tabs labeled B (see Figure 13
on page 11).
3. Gently apply downward pressure to insert the wall plate's
tabs into Magellan's open slots.
4. Insert two screws through the wall plate's screw holes
labeled C and into holes labeled E (see Figure 14 on page
11) in the Magellan back plate.
5. Attach the plastic feet and rubber stops as shown in Figure
15 on page 12.
Figure 15: Mounting Magellan on a Tabletop
Wall
plate
Rubber stops
Tabletop mounting may not be an approved installation
method by local regulations. It is recommended that the
local regulations be verified prior to installing the Magellan
console using this method.

Connecting the Radio Antenna

If the radio's reception is not very good, connect the supplied
radio antenna to the terminal on the back of the Magellan
ANT
console as shown in Figure 16 on page 12. Move the antenna
around until the spot with the best reception is found.
Figure 16: Connecting the Radio Antenna
Back view of the Magellan console.
12
Plastic feet
(x2)
Tabletop
(x2)
Radio
Antenna
Reference & Installation Manual