Troubleshooting - Motorola LA-5137 User Manual

1-6 LA-51XX Compact Flash Adapter Linux Driver User's Guide
1.9.7 Configuring WPA-PSK, WPA2-PSK
You can use wpa-supplicant for configuring WPA-PSK, WPA2-PSK encryptions. You can get more information
about the wpa_supplicant in the README in the wpa-supplicant directory or from the website:
http://hostap.epitest.fi/wpa_supplicant/

1.10 Troubleshooting

1) Problem
Solution
2) Problem
Solution
3) Problem
Solution
4) Problem
Solution
5) Problem
Solution
6) Problem
After installation, I restarted the system but there is no response if I plug-in the card.
Please restart the
cardmgr
looked into. To restart the service, use
service pcmcia restart
When I load the driver, i don't get any messages?
Check the log messages from the
How do I enable Debug Messages in the driver?
Edit Makefile under driver Directory and
add switch -DDEBUG_ON to CFLAGS.
To disable add switch -DDEBUG_OFF.
How do I install firmware?
The firmware file 53821ahif_sh.wrm should be copied to
/usr/lib/hotplug/firmware/ directory.
When you install the driver (ie run make install in the linux-driver directory), the
firmware is copied from the
linux-driver/firmware/bigmac/AHIF/53821ahif_sh.wrm
to
/usr/lib/hotplug/firmware/
How do I confirm/know whether the firmware has downloaded or not?
The message –"FIRMWARE DOWNLOADED SUCCESSFULLY" should appear on
the screen.
command also show the same message after few seconds of plugging in the
dmesg
device.
How do I know whether the device is up or firmware is initialized properly?
service with the card inserted. This issue is being
command.
dmesg