Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Pre-Lighting Checklist
Be sure to check these items before the initial lighting of the insert:
_____ The insert gas label corresponds to the gas supply available
- that is "natural gas" for natural gas or "LP gas" for LP gas.
_____ Gas pressure has been checked carefully.
_____ All gas fittings have been checked for leaks.
_____ All clearances to combustibles have been met.
_____ All combustible materials have been removed from the area
in front of the insert.
_____ All vented areas of the insert face are unobstructed.
_____ House is ventilated to clear initial curing odor.
_____ All packaging materials have been removed from the fire-
box.
_____ While insert is cool, fingerprints or other marks should be
cleaned from any surfaces with a soft cloth. Marks left on these
surfaces may become etched into the finish if not removed
prior to burning the unit.
_____ Brick panels and log set have been installed.
_____ The glass door is in place and is properly sealed.
Your Shoreline™ gas appliance must always be
operated with glass door in place.
CAUTION
Lighting Instructions
STOP! Read the safety information on the front cover of the manual
before proceeding.
1. Open the right side access door. Ensure the gas supply shut-off cocks are
open and ON/OFF Rocker Switch is "OFF". If equipped with a thermostat,
set it to the lowest setting.
2. Turn off all electrical power to the appliance.
3. Push in the gas control knob slightly and turn clockwise
NOTE: The knob cannot be turned from "PILOT" to "OFF" unless the knob
is pushed in slightly. Do not force.
4. Wait five (5) minutes to clear out any gas. If you smell gas, STOP! Follow
instructions on the front cover of this manual. If you do not smell gas
continue.
5. Locate the pilot assembly by looking at the rear center of the burner,
behind the large center log. A blue flame will be seen when the pilot is
lit.
6. Turn the gas control knob counterclockwise
tion.
7. Push the knob all the way in and hold in that position. Immediately light
the pilot by pressing the igniter button several times until pilot is lit.
Continue to hold the knob in for about 30 seconds after the pilot is lit.
Release knob and it will pop back out. Pilot should remain lit. If it goes
out, repeat steps 4-8 holding knob in an additional 15 seconds after pilot
is lit.
• If knob does not pop out when released, stop and immediately call
your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or your gas sup-
plier.
8. After pilot is lit, turn gas control counterclockwise
can only be turned "ON" if the knob has popped out.
9. To turn burner on, turn "ON/OFF" rocker switch to "ON" or set the ther-
mostat to the desired temperature above room temperature.
10. Adjust the flame height (and heat output) by turning the flame height
knob clockwise
for reduced flame
for full flame.
11. Set the blower to the desired air flow after it turns on when the appliance
reaches operating temperature.
to "OFF".
to the "PILOT" posi-
to "ON". Knob
and counterclockwise
21
Advertisement
Table of Contents
