4.9 Adjustment of stopping position
The stopping position is used to control the pause position of the needle bar.
To adjust the stopping position, proceed as follows(Fig.8)
-- Loosen the screw of the positioner.
-- Adjust the relative position between the positioner and the main shaft.
-- After adjustment , tighten the screw of the positioner again
5. THE THREAD, AWL AND HOOK NEEDLE
The thread can be used for this machine: 900D terylene thread. The thread must be dunked in oil
before be used.
Hook needle :
Awl :
Needle protector (Long):
Needle protector (Short):
6. PARTS DRAWING
Fig.7
Fig.8
HN 84/50.140.23 G 1
HN 91/38.140.61 G 201
PY086/909B
PY086/909C
Adjusting lever
Positioner
Screw
5