Heatsource (If Applicable) - Bryant SYSTXBBECW01-A Owner's Manual

Touch the upload photo icon on the menu screen on the Evolution Con-
S
nex Control.
Place the USB drive into the USB port on the bottom of the Evolution
S
Connex Control when prompted.
The control will automatically upload the photo.
S
Once complete, you will receive a confirmation that your photo is
S
loaded.
After you have selected your desired reminders, touch SAVE.
S

HEATSOURCE (IF APPLICABLE)

With the Evolution Connex Control, you can select the desired heat source of your
system, if your system is equipped as a Hybrid HeatR System. Select the HEAT
SOURCE icon from the menu screen.
NOTE: Options available on this screen will correspond to the equipment attached.
The default is for the system to control the heat source.
S
To have only the furnace control, select GAS ONLY.
S
To have only the heat pump, select HEAT PUMP ONLY.
S
To have only electric, select ELECTRIC ONLY.
S
When you have made the appropriate selection, touch SAVE.
S
42
A13116