Using The Navigation Bar; Using The Camera Toolbar - Lorex LNR110 Series Instruction Manual

8 Using the System
3. Click OK to save changes.
NOTE
You must save changes to apply settings changes. It is recommended to adjust one setting at a time
so you can see the results of each change. Click Default to reset the camera to default image
settings.

8.4 Using the Navigation Bar

The Navigation Bar gives quick access to certain functions and menus.
To open the Navigation bar:
• Left click on the screen to open the Navigation Bar. The Navigation Bar has the follow-
ing options:
1. Main Menu.
2. Collapse.
3. Select display layout.
4. Sequence: Click to start/stop sequence mode.
5. PTZ: Click to open PTZ controls.
6. Camera Setting: Click to open camera image settings.
7. Search: Search and playback recorded video. See 15.4 Playback, page 86.
8. Event: View events in progress. See 13.2.4 Event Info, page 51.
9. Channel Info: Click to access status information about connected cameras.
10. Remote Device: Manage IP cameras over the network.
11. Network: Configure network settings for your system. See 13.3.1 Network, page 54.
12. HDD Manager: Manage hard drives connected to the system. See 13.3.17 Format-
ting the Hard Drive, page 67.
13. USB Manager: Click to access options for connected USB thumb drives (not in-
cluded). You can backup video, logs, or system configurations and install firmware
upgrades.
14. System Upgrade: Check for firmware upgrades. The system must be connected to
the Internet to check for or receive updates.

8.5 Using the Camera Toolbar

The Camera Toolbar is used to perform actions on a specific channel.
To access the Camera Toolbar:
• Move the mouse to the top of the channel display. The Camera Toolbar has the follow-
ing options:
#LX400070; r. 1.0/27147/27147; en-US
20