This device complieswith Part 15 of theFCC Rules Operation issubject tothe followingtwo conditions:
This device may not cause harmful interference,and
This device must acceptany interferencereceived, including interferencethat may cause undesired operation.
Changesor modificationsnot expressly approvedby the party responsiblefor compliance could void the user'sauthorityto operate the
(b}) (USA only}
This equipment hasbeen tested and found to comply withthe limits for a Class B digital device,pursuant to Part 15of the FCC Rules.
Theselimits are designedto providereasonableprotectionagainst harmfulinterferencein a residentialinstallation.This equipment
generatesusesand can radiateradio frequency energy and, if not installed and used in accordancewith the instructions,may cause
harmful interferenceto radio communications.However, t here is no guaranteethat interferencewill not occur ina particular installation.
If this equipmentdoes cause harmful interferenceto radio or televisionreception,which can be determinedby turning the equipmentoff
and on, the user is encouragedto try to correct the interferenceby one of the following measures:
Reorientor relocate the receiving antenna.
Increasethe separation betweenthe equipmentand receiver.
Connect the equipmentinto an outlet on a circuit differentfrom that to which the receiver is connected.
Consult the dealeror an experiencedradio/TV technicianfor help.
Tocomply with PCCand Industry CanadaRF exposurelimits for general population/uncontrolledexposure,the antenna(s)usedfor
thesetransmitters must be installedto providea separationdistanceof at least20 cm from all persons and must not be co-locatedor
operatingin conjunctionwith any other antennaor transmitter.
This portabletransmitter with its antennacomplieswith FCC and Industry Canada RF exposurelimitsfor general population/
uncontrolledexposure.This device must not be co-locatedor operatingin conjunctionwith any other antennaor transmitter.
7,1,2 of RSS-GEN
Under Industry Canada regulations,this radio transmitter may only operate using an antennaof type and maximum(or lesser)
gain approvedfor the transmitter by Industry Canada.To reduce potentialradio interferenceto other users,the antennatype and
its gain shouldbe so chosen that the equivalent isotropicallyradiatedpower (e.i.r.p.)is not morethanthat necessaryfor successful
7.1.3 of RSS-GEN
Operation issubject tothe followingtwo conditions:
this device may not cause interference,and
this device must acceptany interference, includinginterferencethat may cause undesired operationof the device.
¸¸NeedNelp? : ! ?
For. = .t .oop=o.=e w. t,ttp=HcuStomer.,o.evwe,:cam;
oro. s toll-free:
® 1 =888=245=1051
Automation and Control Solutions
Honeywell Interrtationat Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
_) U.S. Registered
© 2011 Honeywell
Printed in U.S.A.