Basic Operation; Channel Selection - Toshiba 32W300Ps Operating Instructions Manual

Channel selection

• With the numbered buttons.
Example:
No. 2: Press 0 and within 2 seconds, press 2.
The station stored on CH 2 will appear.
No. 29: Press 2 and within 2 seconds, press 9.
The station stored on CH 29 will appear.
• Press P + or – to change up or down a channel.
This takes approx. 2 seconds.
If the auto search only stored 5 stations, only these
5 will appear. Skipped channels will not appear
(see page 14).
Note:
If the built-in tuner does not receive
anything (e.g. if no antenna is
connected) during TV-operation, then
the TV-unit will change to standby after
approx. 15 minutes.
32L0141B_Eng.indd 17 32L0141B_Eng.indd 17
• Press CH LIST to display CH LIST. Press
to select the desired program, then press CH
LIST to display the selected program.
Note:
In case that the channels exclude preset frequency
in "COUNTRY" selected by "AUTO INSTALLATION"
will be stored in CH LIST, those channel names are
displayed as "– – – – –".
QuickView
button allows you to go back to the last selected channel.
Volume adjusting
Press + or – to adjust the volume. The volume level indicator
disappears after 4 seconds.
MUTE
Press . The sound will be cut off. MUTE will appear for
approx. 4 seconds.
The muting can be released by pressing
Information display
Press . Channel number
and picture size setting
will appear for approx. 4
seconds.
SLEEP TIMER
To set the sleep timer press
. SLEEP and the minutes
until shut-off will appear.
Each time you press the
SLEEP time shown will
change. When the displayed time runs out, the unit will switch to
standby. The display will disappear after approx. 4 seconds
To cancel the sleep timer:
Press repeatedly until '0' appears.
Still picture
Press FREEZE to make a still picture. To cancel the still picture,
press FREEZE again or EXIT.
Notes:
• When this function is not available, 'THIS FUNCTION IS NOT
AVAILABLE WITH THIS SIGNAL.' will appear.
• The still image automatically goes out after 30 minutes.
• The buttons other than
, , +/–, P+/–, CH LIST,
and EXIT are invalid during the still picture.
• When you press INPUT SELECT, 0-9, P+/– or
picture is canceled.

Basic Operation

again or
S T E R E O
A U T O
, , MENU, 0-9, INPUT SELECT,
, AUDIO I/II, FREEZE
, the still
E
or
+ or –.
1
A R D
S L E E P
1 2 0
17
6/7/2007 9:21:16 AM 6/7/2007 9:21:16 AM