Setting The Rinse Aid Dosage - Miele g1022scu Operating Instructions Manual

Before using for the first time

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off using the
K button.
^ Turn the programme selector to the
"12 o'clock" position.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the K button.
Keep the Start/Stop button pressed in
until the Start/Stop indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
22
^ Turn the programme selector to the
"5 o'clock" position.
The Wash/Rinse indicator will flash
briefly three times at intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the Wash/Rinse
programme sequence indicator flashes
tells you the value which has been set
(see chart).
Rinse aid
in ml
0
1
2
3
4
5
6
^ Use the Start/Stop button to select
the rinse aid dosage you want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off using the
K button.
"Wash/Rinse"
flash frequency
-
Once
Twice
Three times
Four times
Five times
Six times