Battery discharge meter installation:
Back to the removal steps
NOTE:
The red, red/green and black wires must be connected
correctly at relevant positions on the battery discharge meter.
Horn removal
1. Take out the key from the ke y switch.
2. Apply the parking brake.
3. Turn Tow/Run switch to TOW.
Please re fe r to Chapter 1 "Protection for Electrical
Safety".
4. Disco nnect the horn wire.
5. Remove the ho rn set bolt
6. Check the horn for continuity.
Replace the part in case of u n-continuity.
Horn installation:
Return to disassembling steps
NOTE:
The horn wire must be connected correctly.
The tightening torque of the horn set bolt is:
9Nm (6.6ft1b)
○
1 and remove the horn.
75