Assembly; B Atteries - TGA sonet Operating Instructions And Owner's Handbook

Table of Contents

Advertisement

10. Range is influenced by many environmental conditions, hills will substantially decrease the range. Establish
what you can obtain around your locality by gradually increasing the distance and checking the battery indicator
at the end of each journey.
11. Reducing the speed will also reduce the power. For climbing obstacles or hills you will need to increase the
speed setting to give the power and then control the speed with the forward reverse levers.
Parking
1. Before leaving the scooter, switch the ignition off, the battery indicator will then go off. Remove the ON/OFF
Key for security.
2. If the Sonet has been used in the Free Wheel mode (see Parking Brake Release), it is VERY IMPORTANT to
re-engage the drive to ensure that the scooter brake is on before you alight.
0
3. Flip up the armrest to make it easier to alight from the Sonet, or swivel the seat through 90
.
5. Assembly (Where Necessary)
The Sonet was pre-delivery inspected and tested prior to despatch. The batteries may have been disconnected
for delivery purposes only.
Remove all the items from the carton and strip the protective packaging materials off each item. Returns are
only accepted when the product is shipped in the original cartons with the original packing material installed.
5.1. Tiller adjustment
Press down the tiller lever and pull tiller up to preferred position. Release lever and ensure tiller has locked.
5.2. Remove Seat
To remove the seat,lower the back of the seat down and pull seat straight up and out.
5.3. Rear Cover Removal
The cover is held in place by 2 spring clips locating onto 2 tubes (fig 7.1). To remove hold the cover at the wheel
arches and pull straight up. Disconnect the rear light cable connectors before fully removing the cover (Fig 6).
1
Fig 6
Fig 7
5.4. Battery Connection
The batteries are already fitted to the Sonet and held by a Velcro strap. For safety reasons in transit they may
have been disconnected. Push the corresponding connectors firmly together on each battery.. They can only
be connected on way (Fig. 7).
5.5. Fitting the Rear Cover
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents