Assembly - TGA Supersport SE Operating Instructions And Owner's Handbook

Intended Purpose
The Supersport is intended for outdoor use and is fitted with large wheels making it ideal for rough terrain and
cross country as well as normal use. It is capable of climbing slopes up to 21% (see technical specification) and
negotiating obstacles up to 12cm. Care must be taken when using in these conditions.
Pavement Use
The speed of the Supersport is dependant on the weight of the occupant, incline and the type of surface. Tested
with a weight of 18 stone (114.55kg) the Supersport had a speed of 7.5/8mph on the flat, on high speed setting.
When used on the pavement, the UK law limits the speed to 4mph. For pavement use make sure 4mph is selected,
and drive with care.
2. ASSEMBLY (WHERE NECESSARY)
The Supersport was pre-delivery inspected and tested prior to dispatch. The batteries may have been disconnected
for delivery purposes only.
Remove all the items from the carton and strip the protective packaging materials off each item. Returns are only
accepted when the product is shipped in the original cartons with the original packing material installed.
Supersport will have had the front wheel and the seat removed. Replace the front wheel and mudguard into the
forks using the components supplied. Ensure the wheel nuts are securely tightened.
1.2
1.5
1.2
1.4
Fig. 1
Rear Cover Removal (wide and extra wide seat) –
Release the seat locking lever found at the middle front
under the seat fig 2 and carefully tilt the seat back.
Remove cover as described in previous paragraph.
Handlebars – These are individually adjustable for
height and angle. Release the securing levers fig 1.3
and set the handlebars to your preferred height and
angle. Re-tighten securing levers. The controls are on
the right hand bar, however left hand controls are
available. If you have the Supersport with extra wide
seat, one handlebar will be shorter than the other, to
allow for offset driving position.
Batteries – For safety in transit the main supply leads may have been disconnected from the batteries. The black
lead would have been disconnected from one battery and the red lead from the other. These will be taped to the
batteries in an obvious position as will the fixing bolts. Simply reconnect the leads ensuring the bolts are correctly
tightened.
Removal and Replacement of Deluxe seat – To remove seat,
release the seat locking lever, at front of seat, and turn seat through
180° so that it faces to the rear. Now lift seat straight up and out.
Replacing the seat is just a reversal of the above.
1.1
Removal and Replacement of Standard seat – To remove seat
release the seat locking lever at front of seat, fig 1.1, and lift the seat
1.3
straight up. Replacing the seat is just a reversal of the above.
Rear Cover Removal – Remove seat, then unscrew the four black
fixing screws located at the top rear and side of the cover (fig 1.2).
Remove cover. Replacement is just a reversal of the above, ensuring the
cover locates correctly. If your Supersport is fitted with the rear basket
then there will be a further two fixing screws holding the basket to the
rear bumper which will need to be removed.
Fig. 2
3
2.1