Cautions In Servicing; Initializing Integrated Network Av Receiver; Service Jig - Denon AVR-2313CI Service Manual

CAUTIONS IN SERVICING

Initializing INTEGRATED NETWORK AV RECEIVER

INTEGRATED NETWORK AV RECEIVER initialization should be performed when the μcom, peripheral parts of μcom,
and Digital PCB were replaced.
1. Turn off the power pressing "Power operation ( X )" button.
2. Press "Power operation ( X )" button while simultaneously while pressing "ZONE2/REC SOURCE" and "DIMMER"
buttons.
3. Check that the entire display is flashing at intervals of about 1 second, and then release the 2 buttons.
The microprocessor will be initialized.
NOTE: • If step 3 fails, start over from step 1.
• All user settings will be lost and the factory setting will be recovered after the set is initialized.
So make sure to note down your setting beforehand for restoring after the initialization.
[AVR-2313CIE3 model]
(X)

Service Jig

When you repair the printing board, you can use the following JIG (Extension cable kit).
Please order it from Denon Official Service Distributor in your region if necessary.
8U-110084S : EXTENSION UNIT KIT
(Refer to 55 page.)
DIMMER
ZONE2 / REC SOURCE
: 1 Set
9