Preparing And Loading Dishes - Crosley ZDM6502AS Use & Care Manual

How your dishwasher cleans
Your dishwasher cleans by spraying a mixture of
hot water and detergent through the spray arms
against soiled surfaces.
pumped through the multiple
Getting Started
1. Load dishwasher (See preparing and loading
dishes) .
2. Add detergent (See ill detergent to the dispenser) .
3. Add rinse aid, if needed
to dispenser) .
4. Close door to latch.
5. Select desired CYCLE See ycle
hart) .The indicator light above the pad will
glow when selected.
6. Select desired OPTIONS See nergy ptions) .
The indicator light above the pad will glow when
selected.
7. Run hot water faucet nearest dishwasher until water
is hot .Turn water off.
8. To start, press
Your selections will only be activated when
the door is firmly closed.
NOTE
The dishwasher is programmed to
remember your last cycle so you do not
have to reset each
dishwasher using the same cycle and
options selected on the previous wash, just
press the Start/Cancel pad.
Wash Cycle Selections
Cycle times are approximate and will vary with
options
dishwasher detergent and melt fatty food soils.
An automatic sensor will check the incoming water
temperature and if it is not hot
be delayed for automatic water heating in the main
wash of all
HI-TEMP WASH is selected a even higher
temperature will be guaranteed to handle heavier soil
loads.
5
See ill rinse
start the
water is necessary to activate
timer will
happens even when
pad.