Clean The Door Gasket/Inside; Air Gap; Protect Against Freezing - Crosley ZDM6502AS Use & Care Manual

Clean the door gasket
Clean the door gasket with a damp cloth to remove
food particles regularly.
Inside
The inside of the dishwasher is self-cleaning with
normal use. If needed, clean the tub gasket with a
damp cloth and use a brush similar to the ones shown
below to clean the opening in the end of the gasket.

Air gap

If there is an air gap
make sure it is clean so the dishwasher will drain
properly.
Air gap is not part of your dishwasher.
Before you clean the air gap,turn off the dishwasher
first and lift off the cover
Remove the plastic cap and clean with a toothpick.

Protect against freezing

Your dishwasher should be protected from freezing
properly if it was left in an unheated place.Have a
qualified person do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the
supply source by moving fuses or tripping circuit
breaker.
2. Turn off the water supply
3. Place a pan under the inlet valve.Disconnect water
line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water
into pan.
To Restore Service:
1.Reconnect the water,drain and electrical power
supply.
2.Turn on water and electrical power supply.
3.Fill both detergent cups and run dishwasher through
a Heated-Wash cycle.
4.Check connections to make sure they do not leak.
17
installed with your dishwasher,