Anti-Tip Bracket Installation - Haier WC200GS User Manual

Dual compartment flex-zone
Hide thumbs

Advertisement

Table of Contents
English

Anti-tip bracket Installation

1. Take off upper hinge cover with upwards motion. Refer to illustrations below:
2. Take the anti-tip bracket and screws from the accessory bag. Tighten the anti-
tip bracket on the top of the product with screws as follows in the illustration.
Note: Follow instructions properly or you may do damage to product.
3. Pull glass door open and attach the anti-tip bracket to counter by screw as
seen below. Adjustment of the leveling legs under the unit may be necessary for a
proper fit in the cabinet opening. Start with the rear legs (if necessary) before you
slide the unit fully into the opening –rise or lower the rear legs to make the unit fit
properly. Then carefully slide the unit into opening as not to damage accidently
cabinetry or the floor. Then perform the same adjustments to the front leveling legs
to bring the front of unit to the proper level to install the anti-tip bracket and fit
evenly under the counter.
4. Another set of anti-tip brackets for side installation is provided as option when
the counter top is granite and hard to fix by screw. This set of brackets include
one bracket and four screws for installation on left side if the cabinet when the
door is left-open or on the right side of the cabinet when the door is right-open.
Below draft illustrates the installation procedure.
6

Advertisement

Table of Contents
loading

  Also See for Haier WC200GS