Simulations - Sharp AR-5015 Service Manual

2. MAINTENANCE DISPLAY SYSTEM
According to the change in toner and developer life, the LED ON timing is changed.
Toner
Remaining quantity check
Remaining quantity
LED
Machine
Developer Life
LED
Machine
Maintenance LED
Machine
1 : Installation of a new toner cartridge allows to display the remaining quantity.
Life
1 a. Press and hold the density adjustment LIGHT key for more than 5 sec, and the machine
will enter the user program mode.
b. Press and hold the "%"key for more than 5 sec, and the remaining quantity will be
displayed on the copy quantity display in one of the following levels: (Remaining quantity
display levels: 100%, 75%, 50%, 25%, 10%, LO)
c. Press the density adjustment LIGHT key to cancel.
NEAR EMPTY
About 10%
ON
Operation allowed
50K
ON at 50K of the developer count.
Selection is available between Not Stop and Stop by Service Simulation (SIM 26-37) Setup.
(If Stop is selected, the LED will flash and stop at 50K)
Default: Not Stop
Clear: SIM 42-1
Selection is available among 50K, 25K, 10K, 7.5K, 5K, and free (no lighting) with SIM 21-1.
Default: 25K
Clear: SIM 20-1
Not stop.
18K
EMPTY
Flash
Stop