Chapter 3. Disassemble and Assemble
3-1 Remove the Stand
1. Lay down the unit so that back cover faces
upward
2. Remove the six screws from the back
cover which are indicated with the circles in the
picture above.
3. Remove the stand
3-2. Remove the Back Cover
1. Remove the thirteen screws indicated (See
picture right.)
2. Then remove the back cover from the
unit.
3-3. Remove the Adhesive Tape
The location of the adhesive tape is shown
below.
3-4 Remove the Terminal Bracket
Remove the two screws indicated by the
red circles in the picture. (See next page.)
Service Manual
Model No.: HL55XZK22a
11